Ejector Pumps vs Sump Pumps
When it comes to protecting your home from sewer and flooding problems, it becomes imperative to install sump and ejector pumps. While many believe that both of these pumps have the same function, they actually don’t.
Sump pumps are used to prevent flooding in areas where houses are below the water table line, while ejector pumps generally are used with a sewage system to help remove sewage. To understand more, let’s take a look at the differences between sump pumps and sewage ejector pumps:
A sump pump is an important part of your home’s water management system. It is generally a small water pump that is installed in the basement of a home, usually in a sump basin (a cylindrical container).
This sump pump is then connected to two inlets at either end of a drain tile system. So, in cases where your home gets flooded with water during rainy days, the sump collects water from the drain tile system and accumulates the water there.
Once it reaches its water capacity, the sump pumps float switch is activated. The accumulated water is then pumped out of the sump pump and basement through a discharge pipe, which delivers the water into a dispersal device or a storm drain.
If this pump fails or does not function properly, your house may be flooded. Sump pumps require electricity to function, but some come with battery back-ups at an extra cost. This provides the needed-electricity for the pump to function during a power outage.
If your house is located in an area below the water table line, it is imperative to install a sump pump. This way you can keep your home protected from any and all water damage and can prevent your basement from getting flooded.
Ejector pumps are similar to sump pumps in appearance and are also installed in a sump basin on your basement floor. However, the task an ejector pump performs is different from a sump pump and is generally used to remove sewage from your home. The ejector pumps basin is responsible for collecting water and sewage from the drains. The ejector pump is connected to a storm drain or dispersal device to deliver water away from your home.
This water is then processed and the lid of the ejector pump will be sealed to prevent any harmful chemicals or gases from entering your home. Failure of this device can create flooding of water and raw sewage that will create various health hazards.
If your house is located in an area that faces issues such as clogged sewage or frequent flooding, then make sure to install an ejector pump. This way, your home will be protected by any possible contaminant or harmful chemicals. Do not delay, protect your home today by installing the right pump.
So, now that you are familiar with the difference between both pumps, determining which pump is required in your home won’t be a problem.